Conflux Technology validated its 3D-printed transmission oil cooler during a full-distance endurance race in a Multimatic Motorsports vehicle.
Hardware
Originally reported by automotivepowertraintechnologyinternational.com
Conflux Technology validated its 3D-printed transmission oil cooler during a full-distance endurance race in a Multimatic Motorsports vehicle. Developed in just two weeks via metal additive manufacturing, the unit delivered 20% higher heat rejection than legacy solutions within the same packaging envelope. This milestone proves that configurable AM cores eliminate the trade-off between rapid design cycles and the rugged durability required for top-tier racing. 🏎️💨 #AdditiveManufacturing #3DPrinting #AutomotiveEngineering #ThermalManagement
This article is an AI-assisted rewrite of the linked source report. Facts originate from the source; phrasing is AMPulse's. Use Read Original below to verify, or Report an issue if something is wrong.